A few questions to help a newbie

[Lee Enfield]

...snip...@ Lee-Enfield
Sadly, the bolt is a mis-match....they didn't have any left with matching bolts...they said they had all gone a couple of years ago from the original batch of 300 rifles that they ordered in. Whether there were any left in Italy still be be distributed...they weren't sure.

As for the barrel...I haven't disassembled the gun so I'm not too sure how old it is...and I'm not really sure if I should take it apart as the RFD said that it had already been proofed anyway (Plus I'd hate to scratch up the stock)

...snip...

remove the center swivel band screw, expand the band keeping the band in the groove and lift the rear handguard from the front section. the barrel should be marked on the re-inforce, similar to the example in my posting above.

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[sumway]

remove the center swivel band screw, expand the band keeping the band in the groove and lift the rear handguard from the front section. the barrel should be marked on the re-inforce, similar to the example in my posting above.

I might try this tonight.

When you say front....do you mean the end closest to the muzzle ?

Am I OK to remove just the rear hand guard by itself ? i.e...there is no need to remove the front hand guard and front sight protectors too ?

Sorry for the questions...just want to make sure I do it correctly and don't break the wood