Quality Hardware question

[new2brass]

The butt plate looks to be late Winchester. From previous picture of recoil plate I noticed you screw has the ++ mark, known as Winchester.
Sling swivel looks good but most likely the original one was lost and that is field replacement.

I have not seen a recoil plate with just a Q in that location but anything is possible. Anyone else?

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[tenOC]

I have not seen a recoil plate with just a Q in that location but anything is possible. Anyone else?

Not seen that, or looked for it. But I have seen a rear flip for an early Quality marked only with a Q sideways on the right side and I'm positive it was original to the Carbine.

[BEAR]

Thanks to the data provided from new2brass I was able to determine that the slide is a Type III. Also thank you to all who responded with comments and suggestions.
With the idea that the butt plate could be a Winchester and the handguard is a Winchester, I will start looking for a Winchester stamp on the stock (just maybe!!!) Would have done it last night but we had grandkids over and my attention was elsewhere.
I don't know the history of this piece but whoever owned it before must have carried it around in a vehicle because there is a lot of surface rust on exposed metal but everything below stock line is in good shape.(normally the opposite is the norm)

[new2brass]

Not seen that, or looked for it. But I have seen a rear flip for an early Quality marked only with a Q sideways on the right side and I'm positive it was original to the Carbine.

I thought the Q rear sight was a topic and could not find it. I posted this elsewhere. It has been suggested it is possibly foreign made



hmm, that did not post in thread

Sideways Q n Sight - The Carbine Collector's Club