1919a4 Information needed

[kenwest516]

fjruple I sent you a pm with my e-mail address. The thick part that your seeing is the right side plate.That is how thick they made it then cut the internals to match so the bolt could be cycled. The barrel can not be removed with the thick side plate in place it hits the edge.
I want to thank everyone here you have been extremely helpful so far .Since a lot has been pointed out to me and I've been all over the internet in the last few days and learned quite a bit about the 1919. I'm considering buying a parts kit. I'm in the display very well so I wont be out much. It seems what I know about it so far the work involved will be more with the display. If I buy the kit it will cost a little more but will be less work.

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[fjruple]

[QUOTE=kenwest516;366475]fjruple I sent you a pm with my e-mail address. The thick part that your seeing is the right side plate.That is how thick they made it then cut the internals to match so the bolt could be cycled. The barrel can not be removed with the thick side plate in place it hits the edge.
I want to thank everyone here you have been extremely helpful so far .Since a lot has been pointed out to me and I've been all over the internet in the last few days and learned quite a bit about the 1919. I'm considering buying a parts kit. I'm in the display very well so I wont be out much. It seems what I know about it so far the work involved will be more with the display. If I buy the kit it will cost a little more but will be less work.[/QUOTE

kenwest 516--

CAn you remove the booster from the end of barrel jacket?

fjruple