Diemaco C7

[Sentryduty]

Look at that, a Short butt, I have one ever seen two of those fitted during my time, rather uncommon pieces.

---------- Post added at 08:56 AM ---------- Previous post was at 08:51 AM ----------

In the same photo of the close up of the butt marking, I notice there is a raised ridge that runs from the rear takedown pin to the stock trunnion, that must be a new lower receiver group update by Diemaco. I don't recall that ridge, on my issued rifles, but will have to go back and check some photos I have. An interesting little design evolution.

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[browningautorifle]

a raised ridge that runs from the rear takedown pin to the stock trunnion

Yes, it's later.

[Sentryduty]

Yes, it's later.

I wonder when that came in? I know my early (19)86AA prefixed rifles didn't have it, but I think the newest I had was a (19)90AA serial range and I cannot recall it.

I seen a couple of (19)93 rifles but I never examined them that closely, the whole a rifle is a rifle, is a rifle thing...

---------- Post added at 12:04 PM ---------- Previous post was at 12:02 PM ----------

Also, Michael, do you need a cleaning kit oil bottle? I have a bunch kicking around I think, some are shipped unfilled too if I remember right.

[browningautorifle]

I wonder when that came in?

I'm too out of date. I didn't even use a C7A2. Saw them at distance.

[CODFan]

Also, Michael, do you need a cleaning kit oil bottle? I have a bunch kicking around I think, some are shipped unfilled too if I remember right.

Yes Sir! Thanks.

I also forgot I had a couple other parts .....