front sight height help

[ActionYobbo]

Everything was set for the factory load. No one seems to take that into account when their load is so far out. How does it do at 100 or 200?

Here, read these.

https://www.milsurps.com/showthread....hlight=zeroing

https://www.milsurps.com/showthread....=zeroing+rifle

read all that but its nothing to do with what I asked.

If I shoot with Mk7 ammo and have to put the sights 100 yards higher than the target range how much lower foresight do I need to put on the rifle? there must be some reference chart to use for this. some one must have worked it out years ago.
With this rifle if I shoot with Mk 7 or my hand loads I hit almost the same spot on the target at 400 500 and 600 but the sights are not calibrated properly. The sights that are on the rifle are replacements that I put on. The front and rear sights were missing and a no drill scope mount was fitted to the rifle when I got it.
I have searched the topics and have not found what I need to know. The other choice is to buy a selection of front sights and try untill I find the correct height.
thanks for helping me with my frustrations

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[browningautorifle]

thanks for helping me with my frustrations

Seems you have a problem then. We've come up with various things...maybe you should go back to the drawing board.