Reloading Data .38 S Wesson High Power Loads Metallic
Is anyone loading .38 SW...
check out post #4
I just looked this up as your powder charge seems really low to me...especially to show pressure signs?? the Enfield service revolver is actually pretty strong and I know several people who commonly fired 9mm Para
(CDN MkI & Brit MkII by the way) from their webley & Enfield .380s with no visible issues [ extremely not recommended, just used to illustrate a much higher pressure than should be possible with the 200gr cast].
I was wondering if perhaps you are seating your bullets in too far? small capacity cases are very susceptible in my experience to seating depth.
the second thought, was: are your chambers clean? if there was excess dried lube or something which could be "gluing" the cases into the chambers? Again this is something I have experienced...Information
![]()
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current.