No.4 (T) for $20 build thread

[jonh172]

About the remaining screws
If you have a dremmel with a fine round diamond head
You can line up the punch mark and dril straight

jsne

This did cross my mind!
I'll be squaring off the tops with an endmill which should giive me a good surface to work with but if that fails thanks for the tip.

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[browningautorifle]

I'll be squaring off the tops

Even if you can just square up a small center it will be enough.