Found: Simson & Co. SUHL Bayonet

[Flying10uk]

The picture, posted in post 3, better shows how the fuller becomes less deep near the point of the blade because the cutter that cuts the fuller is stopped, during manufacture, before it reaches the end of the blade. Because the cutter is round in profile, the depth of cut of the fuller is less deep near the point. The same is true at the other end of the fuller near the cross guard/cross piece. The pictures in post 1 don't show this too well.

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.