Classic Firearms Rockola M14 drawing

[rcathey]

I read a review of the BM-59s they did (basically the same receiver) and the reviewer could pull the op-rod away from the receiver while the bolt was locked up. Such were the "tolerances."
Don't get me wrong, I'm entered in the drawing but merely as a resale item.
I don't guess the link you provided is the one that gets you 50 extra entries each time you use it, is it

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[Nodda Duma]

I don't guess the link you provided is the one that gets you 50 extra entries each time you use it, is it

I primarily posted to share mutual interest and get the community's take on the manufacturer, but momma didn't raise no fool.

Bula Forge and Machine manufactures the M14 receiver...I've read that JRA used either repurposed Garand receivers or new cast receivers (? still trying to track down info)....not sure how much of a correlation there is.

[rcathey]

but momma didn't raise no fool.

Haha, I get that! I used your link just now. Good luck!