Been busy again trying to get reproduction ross parts made.

I sent in one of my 3d files for the MKII 3 Star Nose cap to get 3d metal printed. Received it yesterday and cleaned up the print lines and did a quick cold blue job on it. Image on the left is 3d printed one.

The process of 3d Metal Printing uses 60% stainless steel and 40% Bronze. So it is tough. Used a propane torch on it and didn't distort at all! Way hotter than you would get shooting a bolt action.

I have 3d drawings done on MKII 2 star (Heavy Barrel), MKII 1 Star and Mid bands. These will all be 3d printed. Cost associated with getting stamping dies are prohibitory expensive!

Thanks

Lorne

Left one is 3D Metal Printed.
Uploaded at Snapagogo.com

Uploaded at Snapagogo.com