Are there any supressors

[Chuckindenver]

modern made suppressors that will fit on a 30-06 and still work without being shot off the end?
i would say,, not likely.
even so.
trying to suppress the 30-06 would be hard to do, you may be able to quiet the report, but not the bullet breaking the speed of sound.
many companies make a quality suppressor, but all need a threaded barrel, even the quick release type, will need a threaded barrel to install the housing .
even with a Maxim collectors item, they had issues with it coming loose during testing. few pictures of them damaged

---------- Post added at 09:43 AM ---------- Previous post was at 09:38 AM ----------

with the likely hood of the laws changing regarding Suppressors here in the USA,
i have been gearing up for threading and installing them.
i have a .308 Remington 700 set up with one, as well as an AR15 in 7.62x39 i can tell you the .308 suppressor doesnt work well with the 7.62x39.
the bullet actually struck the inside of the suppressor, i have run a reamer down the suppressor and over sized it a bit.
even with the can installed, it does make a good crack and not like you hear on TV.
with my 10/22 all you hear is the bolt cycling in the rifle, i plan on some more range testing today...

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[PWC]

modern made suppressors that will fit on a 30-06 and still work without being shot off the end?
i would say,, not likely.
even so.
trying to suppress the 30-06 would be hard to do, you may be able to quiet the report, but not the bullet breaking the speed of sound.
many companies make a quality suppressor, but all need a threaded barrel, even the quick release type, will need a threaded barrel to install the housing .
even with a Maxim collectors item, they had issues with it coming loose during testing. few pictures of them damaged

---------- Post added at 09:43 AM ---------- Previous post was at 09:38 AM ----------

with the likely hood of the laws changing regarding Suppressors here in the USA,
i have been gearing up for threading and installing them.
i have a .308 Remington 700 set up with one, as well as an AR15 in 7.62x39 i can tell you the .308 suppressor doesnt work well with the 7.62x39.
the bullet actually struck the inside of the suppressor, i have run a reamer down the suppressor and over sized it a bit.
even with the can installed, it does make a good crack and not like you hear on TV.
with my 10/22 all you hear is the bolt cycling in the rifle, i plan on some more range testing today...

Don't teally cate about bullet report but i want to reduce the muzzle report.