Results 1 to 10 of 28

Thread: Nice saw-cut Inglis Mk.I Bren Kit

Click here to increase the font size Click here to reduce the font size

Threaded View

  1. #6
    Legacy Member TactAdv's Avatar
    Join Date
    Apr 2014
    Last On
    04-14-2025 @ 10:51 AM
    Location
    NE Colorado, USA
    Posts
    238
    Real Name
    Thomas T. Hoel
    Local Date
    06-10-2025
    Local Time
    03:27 PM
    That gun was never imported as DEMILed article of war. With the cuts shown, it never met any relevant import destruction criteria since such criteria began. If it shows no other signs of deactivation, to old standard of DEWAT-ing, then it was brought in under the wire.

    The saw cuts shown very visibly do not even go all the way through both sides, NOT severing the receiver into separate pieces is clearly visible at rear end! One side only cut.

    "Saw cutting" has always not met DEMIL criteria, there was never a point where that ALONE rendered an MG non- contraband. Even during the early 50's period of "wall hanger" guns, they had to meet full DEWAT criteria, before all of them not registered already eventually were declared contraband in 1968. Your gun shown there visibly does not comport to any current standard for lawful possession. Note that Tech Branch is aggressively enforcing their "8 hour" reconstruction rule now for lawful determination.

    There is far more to the story of that gun whether you personally are aware or not.
    - TomH
    Last edited by TactAdv; 02-01-2018 at 03:52 PM.

Similar Threads

  1. My Inglis mk1m Bren
    By Ben Grun in forum The Bren LMG (Light Machine Gun)
    Replies: 5
    Last Post: 07-22-2017, 02:45 PM
  2. Inglis Mk2 Bren
    By Peter Laidler in forum The Bren LMG (Light Machine Gun)
    Replies: 12
    Last Post: 04-27-2015, 12:09 PM
  3. Inglis Bren MkIIM
    By Lee Enfield in forum The Bren LMG (Light Machine Gun)
    Replies: 10
    Last Post: 08-07-2014, 11:01 AM
  4. 1942 Inglis Mk1 Bren Gun
    By Badger in forum The Bren LMG (Light Machine Gun)
    Replies: 13
    Last Post: 12-14-2012, 10:15 AM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts