Dial plates - help.

[Enfieldlock]

Does this mean you are planning to replicate LES 2 dial plates, or am I reading too far between the lines?

We have thought about it, but the engraving would be an expensive process. We have a solution in mind but the present financial climate does not encourage speculation.

The figures could always be applied by a transfer, but I can hear the groans of disapproval from here.

At the moment I cannot see them being offered for less than £100 each, including pointer, washer, pivot and fixing screw.

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[JB White]

Thanks for the reply. I can fully understand the forseen problems with such an undertaking.

[Alan de Enfield]

We have thought about it, but the engraving would be an expensive process. We have a solution in mind but the present financial climate does not encourage speculation.

The figures could always be applied by a transfer, but I can hear the groans of disapproval from here.

At the moment I cannot see them being offered for less than £100 each, including pointer, washer, pivot and fixing screw.

I reckon there is a market at £100 as one just sold on Ebay (item 300309441843) for £103 / $152