1903A1 Action Wrench and Vise Jaw Special Drawings

[rcathey]

So I went for it based on my best engineering guesses.

I see no reason for the wooden inserts to fit so tightly into the metal clamp plates so I made them the same width.

I also don't see why the ends of the wooden insert wouldn't be concentric so I made them concentric.

I did mostly guess on the small end diameter of the wooden insert but it looks to scale so I think that's it.

I left the handle off of the action wrench because it would just crowd the drawing.

I inferred nothing else and believe everything else to be true to the dimensions listed.
I dimensioned my drawings in the manner they did even though the style is a bit outdated (imagine). Hopefully this will allow you to quickly and easily compare.

Let me know if you'd like any changes and what format I should send these files to you.

And thanks for sharing!!

Attachment 93292
Attachment 93293
Attachment 93294

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[usabaker]

Hopefully this will allow you to quickly and easily compare.

Let me know if you'd like any changes and what format I should send these files to you.

And thanks for sharing!!

Wow! that looks great! I hadn't taken it to the machinest yet, because I didn't have a clear set of drawings. I'll PM you. Unexpected surprize, thank you!