Krag Sporter Front Sight

[boomer656]

...I'd just make a front blade out of a dime and file it down until correct...lap it flat on a stone...

Thanks for the idea, but too much 'bling' for my taste. If I was going that route I'd use a penny. It's cheaper and probably easier to work.

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[browningautorifle]

I'd use a penny.

Wouldn't be as close as original sights though... I did make one in past out of flat steel stock though.

[butlersrangers]

At 100 yards, how high is your group above the point of aim?

At 50 yards, where is the group in relation to point of aim?

You may want to try some shots at 200 yards to get an idea of your rifle's trajectory with existing sights.