30-06 neck sizing help.

[Patrick Chadwick]

Well I long since gave up on Lee decapper rods staying put by friction, and simply threaded the top ends and screwed on a nut.

If you have just once had the miserable experience of a Lee decapper rod stuck in a partially sized case with the decapper pin sticking out through the bottom of the case, so that you can't get the case out of the shell holder and thus out of the press, then you will know how annoying those rods are.

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[browningautorifle]

Well I long since gave up on Lee decapper rods staying put by friction

RCBS doesn't have those problems. Yes, tap and thread would sort it out...