Need help identifying the stock on my carbine

[painter777]

jond's carbine,

Receiver: WRA 1,176,194 Spring tube
Rear sight: T2 milled adj.. marked _______
Bolt: T3 round U
Extractor: T_____ marked_____
Firing pin: T_____ marked _____
Ejector: Type _____

Barrel: Type _____ Marked _____ Date____ Other markings ______
If WRA barrel: How far from Muzzle: PW_____" W_____"
*See Note* Barrel P proof stamp: 1 or 2____ Size____ " Distance from muzzle_______"
Front sight: Type______ Marked _____
Barrel band: Type III Marked _____
Gas Piston: Marked ______
Markings on Barrel flat ________
Markings on Gas Cylinder ______
Op Slide: Type______ Marking_____

Trigger Housing: Type III Standard Products- Marked S 13-A
Hammer: Type III SG Flat Hammer (SG not confirmed). Has a Dove/Flame shaped stamp
Hammer Spring: Type II 26 coil
Trigger: Type______ Marked______
Sear: Type______ Marked_______
Safety: Plain Faced Push. Type II or Type III _____ Marked Outside or Inside_______
Magcatch: Type______ Marking on tab______ Marking on frt teeth_______

Stock: Walnut M2, Thought to be SA, Type V
Recoil Plate: If Milled-Type 2 or Type 3. Marking _________ Cast (?) Marking________
Butt Plate: Checker pattern seems to match: ______________ Marking________
Hand Guard: Walnut Type III 4 Rivet. Marked OI... Made by SE Overton for Inland
Oiler: IW
Sling: C tip ends____ D tip ends_____

Note:
** Should be filled out if Barrel IS NOT a Winchester.

Next
You can click on this link and see what a Carbine Club Data sheet looks like.
Print a few copies off.
Study it and compare your parts to the drawings. This can help you ID the Type of part you have.

https://cdn.instructables.com/F6Y/X4...NX0B.LARGE.jpg