Sighting Problems on a late Inland

[USGI]

Jim, I thought the chisel marks (if needed) on Inlands with flip sights were always on the RH side . I've got two of them and they're both "staked" on the right side. One has them both front and rear, and the other one just at the rear. I'm attaching a picture of the one with both. Also, will attach more pictures of the left side area on the late inland. Thanks! - Bob

Attachment 100483Attachment 100484Attachment 100485

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[jimb16]

Jim, I thought the chisel marks (if needed) on Inlands with flip sights were always on the RH side . I've got two of them and they're both "staked" on the right side. One has them both front and rear, and the other one just at the rear. I'm attaching a picture of the one with both. Also, will attach more pictures of the left side area on the late inland. Thanks! - Bob

Attachment 100483Attachment 100484Attachment 100485

Chisel staking could be on either side. It depended on which side was loose. A few of them were staked on both sides! My Inland X-suffix is staked on the left.