Inglis Hi Power Serial Number?

[Lee Enfield]

Nice, thank you for the information. Mine is 0T22XX.

It does not have the No.2 engraving on the slide.

The majority of the "No 2" markings are engraved or handstamped at some later service point.

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[Scout Sniper]

The majority of the "No 2" markings are engraved or handstamped at some later service point.

I have found this to be untrue...

Pistols made approximately before serial 0T27XX were not of Mk1* specification and have no slide markings. They were only on slides of pistols made after this spec change which included;

Barrel lug changed from round to square.
Extractor & ejector modified.

Source of information - Inglis Diamond.

[Lee Enfield]

I have found this to be untrue...

Pistols made approximately before serial 0T27XX were not of Mk1* specification and have no slide markings. They were only on slides of pistols made after this spec change which included;

Barrel lug changed from round to square.
Extractor & ejector modified.

Source of information - Inglis Diamond.

The designations for the Inglis pistols are: No1Mk1, No1MkI*, No2MkI and No2MkI*

The vast majority of both No1 (Tangent rear sight) and No2 (fixed rear sight) pistols were both originally at the Inglis factory marked ONLY with the "MkI*" portion of the designation.

If the No1 or No2 markings are present on the slide, they are (almost) always handstamped (post war in service) [the exception to this are the post war manufactured slides by CAL] to correct the model designation on the gun.

INGLIS DIAMOND HI POWER - C43351 - United States

Here is an "Inglis Diamond" No2MkI* and the model designation is clearly "MkI*"

The "Inglis Diamond" marked guns are said to have been manufactured during the last week of production.

[Bruce McAskill]

I have found this to be untrue...

Pistols made approximately before serial 0T27XX were not of Mk1* specification and have no slide markings. They were only on slides of pistols made after this spec change which included;

Barrel lug changed from round to square.
Extractor & ejector modified.

Source of information - Inglis Diamond.

Your right My serial number is 0T36XX and it is unmarked on the slide. A bit funny in that the author of the Inglis Diamond had all of this information when he was researching the book. He had asked for information and serial numbers and I sent him mine years ago.