New member new IHC Garand

[da gimp]

What is the TE & MW of your barrel, & do you want to sell the barrel? Your IHC should have a LMR bbl.

Quite probably it was built up to match rifle specs by a competition shooter, it is NOT a Type I or Type II NM M1, as those were all built on SA recievers.

Enjoy a good shooter & try to find the right barrel for it.we have a Type II that could stand a better proper bbl.


da gimp

OFC , Mo chapter

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[Dave21]

What is the TE & MW of your barrel, & do you want to sell the barrel? Your IHC should have a LMR bbl.

Quite probably it was built up to match rifle specs by a competition shooter, it is NOT a Type I or Type II NM M1, as those were all built on SA recievers.

Enjoy a good shooter & try to find the right barrel for it.we have a Type II that could stand a better proper bbl.


da gimp

OFC , Mo chapter

At this point I do not want to sell barrel. I want to find out more information on my garand and then find proper barrel before I sell mine. Most of the LMR barrels I have found are shot out. I do not have a TE or MW guage. Acording to the bullet test I have .163 from the muzzle to neck of brass case.