Did someone carve this stock?

[Bill Hollinger]

I don't know about this stock. It has the profile of a type I, II or III but there is no divider forward of the magazine well and is like that of a potbelly M2 stock. Unless that cut has not been made yet??? Strange! It sure looks old and dried out though.

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[edlmann]

I don't know about this stock. It has the profile of a type I, II or III but there is no divider forward of the magazine well and is like that of a potbelly M2 stock. Unless that cut has not been made yet??? Strange! It sure looks old and dried out though.

I wonder if it was pulled off the production line when that deep split in the sling well was discovered.