Drill & Tap 1903A3 receiver

[Chuckindenver]

heres a link to the fixture that needs to be used, to D&T.
even with it, its tough at best.
Universal Sight Mounting Fixture

notice the price???thats why i charge 25.00 a hole, i have to do a lot to cover that cost.:}

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[JBS]

Listen to Chuck on this one. The bit you will have to buy just for this job is a solid carbide three flute available from Brownells. Then you will have to buy the fixture. Have a Smith do the job with the correct tools and make sure they have done this type of receiver before.

[JGaynor]

heres a link to the fixture that needs to be used, to D&T.
even with it, its tough at best.
Universal Sight Mounting Fixture

notice the price???thats why i charge 25.00 a hole, i have to do a lot to cover that cost.:}

Considering what Jiffy-Lube charges for an oil change $50-$75 to drill and tap an 03-A3 is a gift.

Regards,

Jim