Looking for a scope mount

[junkmanted]

the holes are in line some reason the picture looks funny and they also ground down the rear of the receiver look at the 2nd picture .

I think I need to find a mount that will fit the 4 holes done or put iron sites on it I was able to get a left hand peep sight to mount on the rear holes but what to do for a front site I was thinking of getting a 03 front site assembly or use a rem 700 front site I figure it was BUBA IZed already so what the hell.
If the receiver wasnt drilled I would bring it back to mil

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[JGaynor]

the holes are in line some reason the picture looks funny and they also ground down the rear of the receiver look at the 2nd picture .

I think I need to find a mount that will fit the 4 holes done or put iron sites on it I was able to get a left hand peep sight to mount on the rear holes but what to do for a front site I was thinking of getting a 03 front site assembly or use a rem 700 front site I figure it was BUBA IZed already so what the hell.
If the receiver wasnt drilled I would bring it back to mil

ML Stith made a mount that attached to the receiver ring and the side of the receiver bridge. However, I believe the company has been out of business for years so finding one (if thats what it is) could be very tough.

If you know a gunsmith you might see if a Weaver two piece base would at least fit the holes in the receiver ring. Then all you would have to worry about would be adapting the receiver bridge.

Regards,

Jim

[junkmanted]

thanks for the informaton on the mount
I'm hoping to find something that will fit if not I will mod something I do all my own work.