Barrel indexing on a Garand

[Chuckindenver]

i use a level bubble accross the sight ears, and slide the gas cyl, over the barrel, and level the front sight base, when the bubbles match up, your indexed,
remember, check it 2 times before you assemble, sight picture should be straight when you look down the rifle, if its not, you have some adjusting to do.

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[Maddogkiller]

i use a level bubble accross the sight ears, and slide the gas cyl, over the barrel, and level the front sight base, when the bubbles match up, your indexed,
remember, check it 2 times before you assemble, sight picture should be straight when you look down the rifle, if its not, you have some adjusting to do.

Did you actually read my original post?