Shotgun slug shooting

[Bill Hollinger]

You can also use a length of PVC that will fit in the stock and fill it with shot and seal the ends with epoxy. Use foam rubber on the ends so that when you put the butt plate on it compresses the foam enough to keep it from rattling. To remove the stock, remove the butt plate, the PVC falls out and wha-la! No spray foam, no glue, no fuss, no muss!

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[JBS]

You can also use a length of PVC that will fit in the stock and fill it with shot and seal the ends with epoxy.

You are right Bill, and EMT tubing ( Electrical conduit ) works great too. I use half inch EMT poured full of lead to make butt weights for the Garand Shooters. Two in the butt stock was almost 3 extra pounds or close to it if I remember right.