-
Legacy Member
M1 C Fan; this is the place to go to answer you questions:
http://www.machinegunboards.com/forums/
M1a1's-R-FUN!!!!!!!!!!!!!!!!!!!!!!!!
TSMG's-R-MORE FUN!!!!!!!!!!!!!
ENJOY LIFE AND HAVE FUN!!!
-
Thank You to shadycon For This Useful Post:
-
04-16-2020 07:53 PM
# ADS
Friends and Sponsors
-
Legacy Member
Always floors me...why send someone away, he's getting all his answers checked here. He isn't asking anything anyway... What are they going to sort out, there are machine gun owners here too, lots of us.
Sorry; just trying to be helpful. Do you have something against folks looking at more than one site? This is a good site and so it the one in question, I look at both for information. I will not do it again!
M1a1's-R-FUN!!!!!!!!!!!!!!!!!!!!!!!!
TSMG's-R-MORE FUN!!!!!!!!!!!!!
ENJOY LIFE AND HAVE FUN!!!
-
Thank You to shadycon For This Useful Post:
-
-
Legacy Member
Thompson M1 butt stock
Found this years ago at a gun show, bought for the fancy walnut. Plan to sell it in the futureAttachment 107176Attachment 107177
-
Thank You to RCS For This Useful Post:
-
Legacy Member
That`s a beautiful piece of wood RCS.
-
-
Legacy Member
Three months later received my drum magazine. First try ran 5 rounds and the follower was dragging and the bolt slammed it and bent it and the feed rails inside when it closed. Turned out three of the arms dragged when the drum was assembled and the burrs on the edge of the follower grabbed the rim on every fifth round. So instead of throwing it in the blackberry bushes i waited until the next day and spent 4 hrs. straightening and deburring the brand new drum and now it rips through cartridges without a hitch. I am happy with it now but wish they would use a little better QC at the factory on those drums. Found my 2 jams i have had with the stick mags have been a week spring in a used mag. Now that is fixed too and i can`t make it jam. OVER ALL VERY HAPPY WITH IT.
-
-
Legacy Member
All Colt and some contractor drums had nickel plated rotors, needed to be greased with a special tool periodicallyAttachment 109384
-
Thank You to RCS For This Useful Post: