cleaning old ammo

[jmoore]

RJW- Happy news about the baby! Oh, and since this IS your thread you can't hijack it...

Again, Did I EVER recommend tumbling or even bathing loaded ammo? No? So why all the acrimony? I think the questions raised have validity. I merely have a interet in seeing if there actually is test data that can support all these claims of danger. Thanks to JBS for print ing the corporate CYA but it's not data or even study results. I'm thinking that there's good info out there somewhere, I'm just "shaking the tree" a bit to see if any falls out.

As far as statements about surplus ammo go, well...

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[krinko]

Here is a target fired with tumbled ammunition---not .303, because I don't have any ugly enough to tumble.
This is 1970's WCC .223 recovered from the ground somewhere in Central America, tumbled to make it pretty and then sold to suckers in the USA. (I got it cheap from an estate sale, before you jump to any conclusions.)
Just standard 55grain FMJ, fired from an Eagle Arms A2 H-Bar, using standard A2 iron sights, rested on sandbags.
Rate was "semi-rapid", which involves minimal sight alignment and a little less speed than a you-tube mag dump.

Notice the wild dispersion of hits caused by the degraded nature of the tumbled ammunition. Pressure must have been all over the place, too, as I could see the sides of the receiver puffing in and out during the course of the string.
Finally, the rifle blew up and I died.
A needless tragedy.
-----krinko

[enfield303t]

Ed, I would not consider tumbling anything loaded but you say surplus ammo is ammo that failed some test by the military. I can't agree, millions of rounds of surplus ammo is being sold as the country has now decided thru joining things like NATO to change calibres of their military weapons. Perfect example is the Czech 7.62 X 39 that is on the market now. The Czech's now have gone to NATO calibres and have no need for "39" ammo. Of course there will always be some crap on the market but that doesn't make ALL surplus ammo crap. The tins of Czech "39" are sealed and even "pop" when opened proving the contents if stored properly will last for many years to come. Look at all the surplus .303 you could buy years ago, it became surplus as we went to .308 not because it was "bad", I shot some not too long ago and it worked fine.

[Aragorn243]

I have to agree with that last post, surplus also means no longer needed. This can be due to changing calibers of rifles in use, changing mission requirements, or simply needing cash. While some might be due to failing tests, that's probably in the minority with most currently available surplus ammo.

[enfield303t]

Ed you are right in the fact of it possibly being dangerous to shoot tumbled ammo but the far greater majority of surplus ammo has never seen a tumbler and comes in sealed containers. I personally have never purchased any loose surplus ammo other than for my ammo collection and NEVER worry about shooting what I buy. If we didn't shoot surplus ammo most of us would never shoot. My son and I have shot thousands of rounds of surplus 7.62 X 39 ammo and we really don't worry about it. This "never use suplus", reminds me of companies that make product and tell you to only use their batteries or whatever in the item, yeah right, usually they are very self-serving and playing CYA on liability. I will continue to buy and shoot surplus and if it ends up as a disaster I am sure one of my buddies will post my demise.

[Surpmil]

Unfortunately there are two factors that always get involved these days: the obsession with avoiding potential liabilities on the part of businesses and manufacturers, and the good old profit motive: "don't use that no-good old stuff, buy some of our new whoopedy-do ammo!"

From what you've told us of your background Ed, I have the impression that you have many years of doing things strictly "by the book"; which I'm sure is exactly what I would want in someone inspecting equipment I had to use. Commercial manufacturers are not the military however, for whom price is no object, since the rest of us pay for all the equipment.

Like the big to-do over the supposed strength of the Lee Enfield in 7.62mm, I can't help wondering why we are not hearing of problems caused by this practice, if there are any.

Obviously some propellants like cordite are not going to move much in the case, so apparently not much to worry about there.

I also wonder whether all propellants have this issue, or only some.

Military ammo should be made to withstand a lot of movement over protracted periods without any degredation: bouncing around on vehicles and aircraft etc. etc. Some of those scenarious could very easily equal the effect of 15 minutes in a tumbler I suspect.

As for "Internet experts", you'll notice that I do not pontificate, I only speculate in what I consider a reasonable, common sense way based on the information that I have.

[jmoore]

Whilst not on subject, directly, Mr. Horton's link above to JP rifles and their AR10 variant, was rather amusing to me as the majority of 7.62x51 "surplus" ammo that I have fired in recent years all fall on the "bad" list. I've had no dramas with any of it, much of it has been VERY accurate, much more so than US M80 ball, and have had no reliablilty issues.

Excerpt below:

"Much surplus ammunition is not made to exact specifications. We have found that some of this ammunition has caused problems in our rifles due to the use of a tar-like sealant for waterproofing. When this ammunition is used in our rifles, this sealant melts and coats the chamber causing failures to extract and to chamber. Afterwards, any rifle in which this ammunition is used will have the same problem if the chamber and the bore are not cleaned thoroughly. We have found that surplus ammunition from the following countries/manufactures will cause these problems in our rifles:"

South African----------------------------------------[GREAT stuff! I've shot thousands and thousands of rounds!]
Venezuela Cavim ------------------------------------[maybe the worst on the list, but it's OK- esp for LMG use.]
Austrian Hirtenberger ---------------------------------[Very good quality]
Some lots of German----------------------------------[???]
British (underpowered—will not cycle action)---[Just bought a couple more cases recently- no problems]
Indian (overpowered)-----------------------------[Haven't shot much, but it chrono'd OK]
Winchester white boxes marked 7.62"-------------[reliable, accuracy not the best]
[Haven't shot the Wolf brand in this caliber, so i left it off- besides it's NOT surplus- it's commercial ammo made for profit...]

"[]" comments inside square thingies are mine.

Of course I never shot anything other than match ammo out of my AR10(T), but I sold it just because it was REALLY tough to remove stuck live rounds-which were my fault-, but the warning flag was heeded...

ANY of my other self-loading 7.62x51s are happy with any old thing...

BTW- PLEASE don't buy the sealed Portuguese 7.62x51 (FNM)- I want it all for myself!

[Edward Horton]

There are exceptions to every rule and the Communist block countries selling ammunition off to make money is one of them, BUT my Enfields do not shoot 7.62 X 39 ammunition.

The majority of American surplus ammunition is gotten rid of because it fails testing standards, when shot to shot pressure variations exceed limitations the ammo is removed from military inventory is one major reason. To put this in simple terms the ammunition actually failing two test standards, pressure variations and accuracy standards.

Below is krinko's surplus ammunition and its group size.




Below is Ed's 10 shot .303 group keeping his excessive compulsive reloading standards with “NEW” components. Please notice the group size is much, much, much smaller in size.



If you want to go to the range and just make noise and shoot large groups and then pour boiling water down your barrel go ahead and buy surplus ammunition. I'll keep my high standards and make owning firearms a two part hobby....................shooting Enfields and other rifles with good quality ammunition I reloaded.

Below is ballistic testing of new Winchester 30-06 ammunition, look at the extreme variation for pressures, now think about how much extreme variation surplus ammunition has and how it will effect accuracy with even the better lots of surplus ammunition. (older outdated ammunition that failed testing standards)



My surplus 7.62 X 39 ammunition is reserved for my spray and pray AK47 and SKS's.

Surpmil

My Inspectors stamp which is my name was on everything I inspected, and what I inspected would be used by military personnel in the field. The troops in the field didn't get anything with my inspectors stamp on it that wasn't 110% serviceable.

The majority of surplus ammunition does not meet 100% of military testing standards, and is disposed of by selling it off. Hazardous ammunition that failed testing would be disposed of, and surplus ammunition falls into the category of just between ammunition that fails new testing standards and almost being hazardous. (Twilight Zone Ammo)

Tumbling this ammunition could effect the burning rate of the powder and cause higher pressures with even MORE extreme pressure variations.



Flattened primer on 8x57 surplus ammo from higher than normal pressure, this caused the bolt to be very hard to open.



I reload because I want consistency and accuracy and the resulting small groups, tumbled surplus ammunition doesn't fit this category and never will.

[enfield303t]

Have shot the South African in two different guns (semi-auto and bolt action) and must agree it is very good and very accurate. One thing some modern Winchester .308 in a white box marked for "Police and Prison use only not for resale" has been showing up at Guns Shows here in B.C. The outer carton appears normal and nothing listed as to what you find inside. This is the first time I have seen it, bought a case and it seem to be good ammo, and I know it is not military surplus but it is something surplus.

[jmoore]

Where did 7.62x39 come into the picture?

Mr. Horton's link above was discussing 7,62x51 (including Wolf) in a Non-Enfield. I've shot the ammo mentioned in an Enfield or three (L42a1s AND L1a1, Plus some Ishapore 2A1s). The L42a1s shoot some lots of British L2A2 ammo about 1 1/2 MOA or a bit better, so I'm pretty satisfied!


Is some surplus ammo absolute hammered dog poo? YES! But some is super fanatstic. Plus, some .folk REALLY don't need to be reloading...like me, right now-no time!

But,back to RJW's original topic, Mr. Horton, how do you recommend degreasing loaded ammo? My way is labor intensive- rubbing each one w/ a cloth- minimal solvent as required.