-
Legacy Member
6.5 Carcano Reloading ---> Hornady .267 Expander Ball Question
I want to start reloading 6.5 Carcano using the Hornady .267 bullet.
I only have an older RCBS 6.5 die set that has a .264 expander ball.
I would like to know if the Hornady expander ball will fit on the RCBS Spindle.
The thread is a standard 10-32. (See attached photo)
I do not necessarily care about the de-capping pin being different.
I would appreciate it if someone with a Hornady die set could check this out for me.
Perhaps even supply the other thread sizes to compare with the RCBS spindle.
.
http://www.honos.org/photos/spindle.jpg
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
-
11-11-2017 01:41 PM
# ADS
Friends and Sponsors
-
Contributing Member
I’d love to help, but I really don’t know your Hornady equipment.
I always used military bullets, but with a half bought and half home-made reloading system.
Only thing I can recommend is to use bullets bigger than .264 and a tad smaller than .268.
Not much, unfortunately...
34a cp., btg. Susa, 3° rgt. Alpini
-
-