-
FREE MEMBER
NO Posting or PM's Allowed
New Remington problems
Okay, I am not new to guns but my son just bought a Remington 03A3. Whenever I cycle the bolt, the firing pin goes forward with the bolt, it doesn't remain cocked. Am I missing something stupid or is there something wrong?
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
04-18-2014 10:11 PM
# ADS
Friends and Sponsors
-
Legacy Member
Originally Posted by
Newto03A3
Okay, I am not new to guns but my son just bought a Remington 03A3. Whenever I cycle the bolt, the firing pin goes forward with the bolt, it doesn't remain cocked. Am I missing something stupid or is there something wrong?
The firing pin can't go forward with the bolt unless something is wrong. I suspect it's the firing pin lock being worn or a bad sear. Pictures? Regards, Rick.
-
-
-
FREE MEMBER
NO Posting or PM's Allowed
It has something to do with the stock, when I loosen the stock mounting bolts, it works properly. But the stupid sporter stock gets in the way of the bolt. I had to loosen the stock to get the bolt out.
I assume the firing pin lock is the little serated button just behind the bolt when it is in the locked position? Because that doesn't move at all until I loosen the stock too.
Last edited by Newto03A3; 04-18-2014 at 10:51 PM.
-
Legacy Member
Originally Posted by
Newto03A3
It has something to do with the stock, when I loosen the stock mounting bolts, it works properly. But the stupid sporter stock gets in the way of the bolt. I had to loosen the stock to get the bolt out.
I assume the firing pin lock is the little serated button just behind the bolt when it is in the locked position? Because that doesn't move at all until I loosen the stock too.
You didn't say anything about a sporterized stock and I can't help you other than to say it is not inletted properly. There is too much wood somewhere. Good luck. Regards, Rick.
-
-
Legacy Member
Sounds like the stock is hitting either the trigger or depressing the front edge of the sear. Take the bolt out, all but remove the screws, watch the sear as you tighten the screws, if it starts dropping you'll probably need to relieve the stock in the sear or trigger area.
When people remove material from the sear or firing pin in an attempt to reduce travel, they create a similar problem. Very little movement of the trigger or sear could make it fail. Make sure there is ample engagement it should not have a hair trigger. IIRC there should be around .125 angagement.
-