Hey guys it was pointed out that I should post this over here too.
I have a very fresh '44 Longbranch that was FTR'd to No4 Mk1/3 status at Faz in '51. The rifle had been bubba'd but barely even shot (or handled).
I am restoring it back to full wood and installing a Repro No32 MkI scope on a repro mount and pads, and all the T trimmings.
Can anyone tell me the exact drill bit sizes and tap sizes I need to do the conversion?
I also need some pointers on the soldering procedure for the pads, what type of solder to use etc.
Thanks!
Range report hopefully to come after the weekend (sans scope)Information
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current.