Hey guys it was pointed out that I should post this over here too.

I have a very fresh '44 Longbranch that was FTR'd to No4 Mk1/3 status at Faz in '51. The rifle had been bubba'd but barely even shot (or handled).

I am restoring it back to full wood and installing a Repro No32 MkI scope on a repro mount and pads, and all the T trimmings.

Can anyone tell me the exact drill bit sizes and tap sizes I need to do the conversion?

I also need some pointers on the soldering procedure for the pads, what type of solder to use etc.

Thanks!

Range report hopefully to come after the weekend (sans scope)
Information
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current.