Glock G34 9mm

[Newsfeed Hound]

According to the manufacturer, the Glock pistol was the first "industrially manufactured handgun with high-tech polymer grips." The barrels and slides are coated with what Glock describes as a "high-tech surface refinement" that they call Tenifer. The benefits of this "carbonitriding" coating are not only corrosion resistance and reduced glare but also resistance to abrasion. Tenifer coating is highly rated on the Rockwell Cone hardness scale at 64 HRC.Some Glock pistols are available with different color frames, but our G34 was basic black. The defining feature of the G34 was its long 5.3-inch barrel with polygonal rifling, covered by a slide that included a gaping hole just to the rear of the front sight. This relief measured approximately 1.75 inches long by 0.75 inches wide. Glock says that this serves to reduce stress on the frame. The dustcover beneath the slide was also longer, making room for a healthy sized accessory rail, which was molded into place. The schematic breakdown of the Glock pistol with magazine lists only 34 separate parts, 36 if you count the magazine insert at the base plate (part 32a), and the front sight blade, part number 16a.

More...

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.