![]()
With thanks to Advisory Panelmember Peter Laidler
, a new article has been added to the Technical Articles for Milsurp Collectors and Re-loaders (click here).
L59A1 DP Rifle (by Peter Laidler) (click here)
As Peter says …. "Putting my old teaching hat on and remembering the phrase that one picture describes a thousand words, here are a series of pictures showing the important points of what one of these mysterious ‘rifles’ embodies."
Peter has added a personal request in regards to this article.Article Extract .....
That was a timely picture by tlvaughn (click here) of his selection of No4 rifles which included a shot of an official No4 DP rifle, known to us in the UKMilitary as the RIFLE, DRILL PURPOSE, L59A1. I expect that some of the wild and untamed colonials and antipodeans among the forumers have been at their wits end trying to decipher what we unwashed Brits have been chuntering on about during our recent discussions about an Enfield Rifle
that is incapable of firing anything, but is still a rifle…….called ‘……..an L59!’ The L59 was a downgraded rifle converted to a non firing, totally inert rifle for training use with Cadets (and not only Cadets I should add). Incidentally, numerically this is the last Lee Enfield. While there were 6 L59A2's, that should be looked upon as a sample run. That fact makes a genuine L59 a cheap but important item in any collection of Lee Enfields. …...
The left side of a typical L59A1 Drill Rifle. Notice the distinct, wide white bands on the butt and fore-end/handguard. This particular rifle had a blunted/rounded tip DP marked bayonet fitted too. There doesn’t appear to be any official EMER reference to DP No4 bayonets in the relevant EMER SA&MG V150 but this bayonet bears a label with the distinct red ‘S’ for serviceable which is lined through and now reads ‘…to EMER DP spec’. On the basis that if it is DP, it cannot be truly serviceable.
(Click PIC to Enlarge)
Note: If you have any questions or don’t understand something or my instructions are ambiguous then please ask on the forum and NOT by PM (Private Message). That way everyone will get the benefit of the question and answer.
Regards,
BadgerInformation
![]()
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current.