Hi guys, I'm rebuilding a No4 in 7.62, and have "that feed issue". Previously I've been able to get them running by tweaking the tabs on the mag, but I cant see this one obeying.
It needs to sit just about 1-2mm higher for the bolt to pickup the round on the right hand side of the stack.
I've got Peter Laidlericon's drawings of where to mill it out in a Skennertonicon book, but I'm not so flash on a mill and don't want to stuff it up.
I was hoping for some very specific advice on how to jig it up/set the receiver (and barrel) up on the mill properly to as much as possible avoid 1st timer dramas.
Thanks.
Information
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current.