-
FREE MEMBER
NO Posting or PM's Allowed
Early M3A1 tool
This is an early M3A1 tool using the type 1 blade with a notch cut for the pin punch.I'm not certain however if the brush is original or a replacement.It looks like a brush from an MAS French
made tool.I've emailed Mr. Ricca to get his opinion about the brush.The tool appears new and never used.
Information
 |
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
Last edited by Rifleman; 06-23-2012 at 07:02 PM.
-
06-23-2012 07:00 PM
# ADS
Friends and Sponsors
-
Senior Moderator
(Milsurp Forums)
I believe there was a thread that Bill Ricca did about the way to tell. The end is soldered I think.
Real Versus Fakes: Chamber Brushes
Bill Hollinger
"We're surrounded, that simplifies our problem!"
-
-
-
Advisory Panel
(Deceased Feb 2023)
I answered his email. He has an early WWII M3A1* with an after war French brush.
* I am still not sure it is an early model. Some of the characteristics of that type of tool make me think it might be a tool made up by a depot from spare parts (excluding that brush). It too long to go into.
-
The Following 3 Members Say Thank You to Bill Ricca For This Useful Post:
Register To Reply
