Remington 1903

[Grandpa8]

Did Remington ever use unmarked bolts in their early transitional 1903's?

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[Rick the Librarian]

Nope ... unless the inspector was having an "off" day. Is the bolt handle "bent" or straight?

Any markings on the safety lug halfway up the bolt handle?

[Grandpa8]

Thanks for the reply Rick. Handle is bent but see no markings.

[Grandpa8]

I understand some SC bolts were unmarked. Is it possible a Remington 1903 could have an A3 SC bolt in it?

[Rick the Librarian]

I understand some SC bolts were unmarked. Is it possible a Remington 1903 could have an A3 SC bolt in it?

Nope, not as "original equipment".

[Tom in N.J.]

There were a batch of unmarked Chinese made M1903 bolts a few years back... the sales story may have been "Unmarked S-C, or RIA" or what ever the buyer needed.