Recently aquired a pretty nice Faz No4 Mk2 dom 5/50. Pre-inspection indicated light to little muzzle pressure but everything else looked good so now its mine:}. Dis-assembly inspection indicates that the draws, body, and knox fit in the forend is really good wrt to spec however there's minimal muzzle pressure. Sighting down the forend it appears that the muzzle end is warped down a bit and runs away from the barrel such that there's little contact at the muzzle bearing bed. I seem to recall that Peter L commented on this briefly and discussed a means of installing a new muzzle bearing in the forend. Can anyone point me to this post please?
Information
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current.