+ Reply to Thread
Results 1 to 9 of 9

Thread: Sierra 180 gr and Norma #202 data?

Click here to increase the font size Click here to reduce the font size

Hybrid View

  1. #1
    FREE MEMBER
    NO Posting or PM's Allowed
    Richard Hare's Avatar
    Join Date
    Mar 2015
    Last On
    11-08-2018 @ 09:04 AM
    Location
    Alberta, Canada.
    Posts
    242
    Real Name
    Richard Hare.
    Local Date
    06-10-2025
    Local Time
    01:58 AM

    Sierra 180 gr and Norma #202 data?

    Morning all,

    Years ago, I had a very good load for the .303 that used the Sierra 180 gr. PSP and Norma # 202 powder.
    Lost my data for it! Tried looking it up, but can't find it anywhere.
    Does the Sierra manual list Norma #202 powder?

    Why I ask, is I just found a couple of cans I'd forgotten about, and would like to try it again.

    Thanks for any help!

    Richard.
    Information
    Warning: This is a relatively older thread
    This discussion is older than 360 days. Some information contained in it may no longer be current.

  2. #2
    Contributing Member smle addict's Avatar
    Join Date
    Dec 2011
    Last On
    Yesterday @ 04:33 PM
    Location
    CA, USA
    Posts
    493
    Real Name
    A. G.
    Local Date
    06-10-2025
    Local Time
    01:58 AM
    Just checked my sierra (edition 5) manual. No Norma powders were listed.

    I have a new Norma manual, but it only lists load data for 150, 174, and 215 grain bullets. I can post that page if you like.
    Last edited by smle addict; 07-26-2016 at 10:35 AM.

  3. #3
    FREE MEMBER
    NO Posting or PM's Allowed
    Richard Hare's Avatar
    Join Date
    Mar 2015
    Last On
    11-08-2018 @ 09:04 AM
    Location
    Alberta, Canada.
    Posts
    242
    Real Name
    Richard Hare.
    Local Date
    06-10-2025
    Local Time
    01:58 AM
    Thread Starter
    Good morning SMLE,

    Thanks for the reply.
    I did see the data for Horndy bullets and Norma powder. Maybe I used this as a reference. Been along time!

    If you could post what you have, it may be very helpful though.

    Thank you!

    Richard.

  4. #4
    Contributing Member smle addict's Avatar
    Join Date
    Dec 2011
    Last On
    Yesterday @ 04:33 PM
    Location
    CA, USA
    Posts
    493
    Real Name
    A. G.
    Local Date
    06-10-2025
    Local Time
    01:58 AM
    Taken from Volume 2, Norma manual, dated 2013.

    Hope this helps!

  5. #5
    Advisory Panel browningautorifle's Avatar
    Join Date
    Jul 2008
    Last On
    Yesterday @ 09:09 PM
    Location
    Victoria BC
    Posts
    31,124
    Real Name
    Jim
    Local Date
    06-10-2025
    Local Time
    01:58 AM
    Regards, Jim

  6. #6
    FREE MEMBER
    NO Posting or PM's Allowed
    Richard Hare's Avatar
    Join Date
    Mar 2015
    Last On
    11-08-2018 @ 09:04 AM
    Location
    Alberta, Canada.
    Posts
    242
    Real Name
    Richard Hare.
    Local Date
    06-10-2025
    Local Time
    01:58 AM
    Thread Starter
    Thank you SMLE, I have saved that!

    Thanks for the PDF link as well Jim, I think I can start lower and use these figures.

    If only I could remember what I did with my old data. It hung on the wall above the press, and I suppose I "tidied up" at some point! :-)

  7. #7
    Advisory Panel browningautorifle's Avatar
    Join Date
    Jul 2008
    Last On
    Yesterday @ 09:09 PM
    Location
    Victoria BC
    Posts
    31,124
    Real Name
    Jim
    Local Date
    06-10-2025
    Local Time
    01:58 AM
    With all those powders gone for ages, I don't doubt you cleaned up a bit and it went out.
    Regards, Jim

  8. #8
    FREE MEMBER
    NO Posting or PM's Allowed
    Richard Hare's Avatar
    Join Date
    Mar 2015
    Last On
    11-08-2018 @ 09:04 AM
    Location
    Alberta, Canada.
    Posts
    242
    Real Name
    Richard Hare.
    Local Date
    06-10-2025
    Local Time
    01:58 AM
    Thread Starter
    Quite right Jim, but then a couple of cans of Norma #204 turned up (Excelent for the 6.5 x55!!) Plus 2 1/2 cans of #202, and I really liked that in the .303. I thought I'd used all that powder years ago.
    Dunno where it came from...

    Have loaded up a few to try in the old MLE Mk 1 with a worn -out barrel. Will keep you posted. (said gun has a tight chamber still, so that's nice!)

  9. #9
    Advisory Panel browningautorifle's Avatar
    Join Date
    Jul 2008
    Last On
    Yesterday @ 09:09 PM
    Location
    Victoria BC
    Posts
    31,124
    Real Name
    Jim
    Local Date
    06-10-2025
    Local Time
    01:58 AM
    I've had older powders given to me and too, been forced to consume them...
    Regards, Jim

+ Reply to Thread

Similar Threads

  1. Norma Berdan Primers..??
    By Mike Haas in forum Ammunition and Reloading for Old Milsurps
    Replies: 11
    Last Post: 01-11-2011, 01:14 PM
  2. 1957 Norma Ammo
    By INLAND44 in forum M1/M2 Carbine
    Replies: 3
    Last Post: 09-15-2010, 10:10 PM
  3. Sierra going 24 hrs 7 days production
    By Pelago in forum The Watering Hole OT (Off Topic) Forum
    Replies: 5
    Last Post: 09-27-2009, 09:49 PM
  4. Sierra 77 Hpmk
    By GBEAR1 in forum Ammunition and Reloading for Old Milsurps
    Replies: 2
    Last Post: 03-31-2009, 07:23 PM
  5. Norma M96 pricing
    By sdh1911 in forum Commercial Auction and Sale "Gossip"
    Replies: 2
    Last Post: 12-12-2006, 09:34 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts