-
Legacy Member
Ross M10 Will not fire with closed bolt
I have a ross M10 new to me and I was looking at it trying to dry fire to check function only and it will not fire when the bolt is fully closed. When the bolt is partially closed it will release and the bolt closes. I pull the receiver out and looked at the trigger mechanism and the exterior of the bolt and everything looks correct. Its almost as if the trigger isn't moving far enough.
I need help to figure this out. Any suggestions?
Information
 |
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
-
10-28-2020 07:30 AM
# ADS
Friends and Sponsors
-
Advisory Panel
Is the firing pin cocked or uncocked when the bolt is closed by hand?
“There are invisible rulers who control the destinies of millions. It is not generally realized to what extent the words and actions of our most influential public men are dictated by shrewd persons operating behind the scenes.”
Edward Bernays, 1928
Much changes, much remains the same. 
-
-
-
Legacy Member
I got it fixed. After some polishing and smoothing of rough edges it is fixed and works like butter. Now I need a rear sight leaf and a front sight blade and hood
-
-
Legacy Member
For the front sight blade and hood you can get those parts from
Ross Rifle Restoration
I bought a hood and handguard from him last year and both parts were very good. Hope this helps.
-
The Following 2 Members Say Thank You to Patton12 For This Useful Post:
PM
