Handguard op rod relief cut transition.

[HoosierNative]

Looking for the serial number range when the handguard op rod relief cut was used.

Thanks

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[Tom Doniphon]

Is it an SA or WRA hand guard.? If I recall correctly, SA was making the clearance cut by mid 1941 or around serial no. 250,000. WRA didn't start making the cut until around the 2.4 mil range.

[HoosierNative]

thanks