No2 MK1 End Shake

[Patrick Chadwick]

Maybe someone out there has Gun Digest copies around 1960-5. I once read an article explaining very plausibly that a revolver needed a touch of end shake. If I remember clearly (and I hope this can be checked) the argument was on firing that the pawl will first push the cylinder as far forwards as it will go. The case will initially expand to grip the chamber walls, the primer will be pushed back, and then the cartridge base will be pushed back onto the recoil plate. Microseconds later the cylinder will be pushed back, thus shoving the case back into the chamber and recovering some end play so that the cylinder can rotate. If the cylinder has no end play whatsoever, then it cannot move back and the revolver will jam up pretty quickly as powder and lubricant residues get between the back end of the barrel and the front face of the cylinder.

Thinking it through, this seems to imply that if the gap between cartridge base and recoil plate is X thousandths of an inch, then you need a similar amount of end play to make sure that the recoiling cylinder can press the cartridge back into the chamber again. It would explain why my Swiss 1882 revolver, make with watch-like precision and just about zero end play, jams solid after one complete cycle of the cylinder - it is too precise - too closely fitted for the black powder load!

I realize that I might just be talking twaddle, and hope that in that case someone will politely put me right!