This evening i disassemlbed sear and trigger. Not so simple thing to do because 1) i hit my index finger using hammer 2) i lost sear axis. beacuse i hit it too hard , using hammer. So what nail could i use in order to re build sear axis?

And second question: how can i obtain a crisp, two stage, trigger weight of 3 pounds + 1 ounce ( that means 1,5 kg, minumum allowed for military match here)?

First, i prefer to polish sear surface s that engagé ribs and cocking bent.
Second, i would polish trigger ribs, but how sould i use to do this ona safe manner? Stone couldn't follow rib' silhouette. After that i'll re check trigger wheight.

At the end i could slide cocking bent on a 6000 grit honing stone, only a few times.
Is it possible to polish trigger and sear axis?

I'm in doubt..i'll do nothing before rading your advive.
Information
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current.