Mags not reliably feeding on an Ishapore 2A1

[Dieudonne' Saive.]

It's like the bottom of the bolt, is not grabbing the case head a it passes. Multiple slow, deliberate passes of the bolt will not pick up the tail of the round at all. This is different than the round being picked up, but not chambering.

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[Lee Enfield]

It's like the bottom of the bolt, is not grabbing the case head a it passes. Multiple slow, deliberate passes of the bolt will not pick up the tail of the round at all. This is different than the round being picked up, but not chambering.

remove the magazine, re-insert, seat the magazine with a good hard slap, and try again.

Sometimes the magazine don't fully seat (even though it clicks in and you cannot make it move deeper).

[Dieudonne' Saive.]

remove the magazine, re-insert, seat the magazine with a good hard slap, and try again.

Sometimes the magazine don't fully seat (even though it clicks in and you cannot make it move deeper).

Of course. But ALL FOUR mags are encountering the same issue. I even applied upward pressure on the mags after being seated to simulate this BTW.