Gas cylinder 2.5M - correct one?

[Scott2K]

The straight (90' and there were two: the earlier .050" and later .035) cut predated the diagonal cut(mid '44), but by '44 they were only using the cut cylinders if there was excessive play found in rebuild. -mostly Duff-

So for Feb '44 it would be a straight .035 cut or .050?

-Scott

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[Ramboueille]

So for Feb '44 it would be a straight .035 cut or .050?

-Scott

Scott,

Before we get too far along here, sawcut gas cylinders were not part of original new built assembly, they are strictly field rebuilt and overhaul items.