Enfield Enforcer - Update

[Alan de Enfield]

Thanks for that Al - nice one - they're hard to find these days> I think two's just being greedy!

If I remember correctly you turned down 483 as the reticule was upside down etc.
I looked at the reticlue on 134 and saw it just needed turning around (internally) and bobs-your-uncle. The cross hair on 483 had become detached from the reticule in shipping but the seller had a spare reticule (the same type 2) which he sent me FOC cannot say fairer than that !!!
Added a PH5E/4 (that I happened to have lying about) and its complete.
Had it out again tonight and shot sub 1" groups so subject to weather its off to the range on Saturday.

For the price - a bargain.
A bit of turps substitute and 0000 wire wool, to get the greasy marks off, loads of BLO and it'll be as good as new.

The 'Enforcer clone' I built is now up for sale (less the PH5E/4). I may strip it down as the various bits (bipod, magazine, PH mounts, PH rings, scope, butt, forend and handguard etc will undoubtably fetch more on flea-bay than the complete rifle would sell for to a dealer.

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[PrinzEugen]

If I remember correctly you turned down 483 as the reticule was upside down etc.
I looked at the reticlue on 134 and saw it just needed turning around (internally) and bobs-your-uncle. The cross hair on 483 had become detached from the reticule in shipping but the seller had a spare reticule (the same type 2) which he sent me FOC cannot say fairer than that !!!
Added a PH5E/4 (that I happened to have lying about) and its complete.
Had it out again tonight and shot sub 1" groups so subject to weather its off to the range on Saturday.

All's well that end's well then Alan - glad you're pleased with it.