ammo for svt40

[finnigan74]

I was wondering if 180 grain prvi partizan soft points would function properly in a svt40? Or should I look for something in 150 grain?

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[jmoore]

Haven't tried 'em. If they feed, just adjust the gas system for best function- start small and work up! (Don't forget the wrench, I did that last time and shot a straight pull all day.)

Welcome to the forums!

[arado]

SVT40 used heavy and light ball issue ammo. 147--176 parameter. CORROSIVE. KEEP IT CLEAN, LUBRICATED/adjusted. I personally use 147 FMJBT non corrosive Easier on gun and me. Gary

[finnigan74]

Would using the 180 grain round cause excessive wear on the gun? I was'nt planning on using an excessive amount, maybe 1-2 hundred rounds until I can find some 150 grain.

[jmoore]

Its about the same weight as Soviet heavy ball (yellow tip), so technically, its probably OK. Its really more about burn rates and gas port pressure.