mounting PH rings on Enforcer

[watty12]

might be a stupid question, what is the correct side to have the mounting screws when fitting PH rings to Enfield Enforcer? I have seen numerous images and they shoe them fitted both sides. I would assume the screws should go on the left.

Confused

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[Gil Boyd]

Hope this helps answer your question:

[Lee Enfield]

Hope this helps answer your question:

Hey Gil,
the rifle in your picture isn't wearing PH rings.... ;-)

Attachment 88003

Here is a PH rifle with PH rings which can only be mounted in one direction.

Generally rings with large threaded knobs are mounted to the left side to minimize interference with bolt operation.

I have swapped ring directions when there are scope windage concerns (quite often rings and base combinations will not be in line with the bore).

[Gil Boyd]

just testing................ it was a late night and fired the first Enforcer picture I put my fingers on. Certainly LHS to answer the question I omitted initially.