Underwood M1 Carbine evaluation

[jasonafair]

Attachment 116504Attachment 116495Attachment 116496Attachment 116497Attachment 116498Attachment 116499Attachment 116500Attachment 116501Attachment 116502Attachment 116503Attachment 116494Attachment 116505Attachment 116506Attachment 116507Attachment 116508Attachment 116509Attachment 116510Attachment 116511Attachment 116512Attachment 116485Attachment 116477Attachment 116478Attachment 116479Attachment 116480Attachment 116481Attachment 116482Attachment 116483Attachment 116484Attachment 116476Attachment 116486Attachment 116487Attachment 116488Attachment 116489Attachment 116490Attachment 116491Attachment 116492Attachment 116493

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[browningautorifle]

Wow, that one's sure been around. Well used to say the least.

[jasonafair]

Wow, that one's sure been around. Well used to say the least.

Around here that is one of the better condition ones.

[USGI]

Is that one from RTI? - Bob

Attachment 116516

[jasonafair]

Is that one from RTI? - Bob

Attachment 116516

Supposedly from a private collection.
From the feedback so far, is it safe to assume that a strip and BLO the wood probably won’t hurt the value?

[jond41403]

What does that faint marking say on the left side of the receiver ring?

[browningautorifle]

is it safe to assume that a strip and BLO the wood probably won’t hurt the value?

If it was me, I'd strip bead blast and parkerize. The wood needs a complete degrease and rejuvenate too. Then it'll be right. Still will be a shooter.

[painter777]

Is that a broken / chipped tooth on the trigger housings mag catch..... On the TH not the actual Magcatch ?

A good stock cleaning sure wouldn't hurt it. Best to coat the wood with RLO.

---------- Post added at 01:21 PM ---------- Previous post was at 01:16 PM ----------

What does that faint marking say on the left side of the receiver ring?

JD,
Looks to be MEREX SAV., GA

Per Jim Mock:

Mertins Export (MEREX AG) office at Combat Military Ordnance Ltd. in Savannah, GA
estimate 1984-1987

3/4 down the page:
U.S. Carbine Imports & Exports

[jasonafair]

Is that a broken / chipped tooth on the trigger housings mag catch..... On the TH not the actual Magcatch ?

A good stock cleaning sure wouldn't hurt it. Best to coat the wood with RLO.

---------- Post added at 01:21 PM ---------- Previous post was at 01:16 PM ----------



JD,
Looks to be MEREX SAV., GA

Per Jim Mock:

Mertins Export (MEREX AG) office at Combat Military Ordnance Ltd. in Savannah, GA
estimate 1984-1987

3/4 down the page:
U.S. Carbine Imports & Exports

Thank you for the Merex id. I’d never had made that out. When I get home I can take some more pictures of the mag catch.
I’m hoping a good scrubbing will help.

[painter777]

@ jasonafair,

Are there any Rivets in the back of your hand guard?

Also one picture looks like a Hole inside the trigger loop on the forward side. May just be the picture... but it sure looks like one. If it 'Is' a hole, I have never seen this before

See this one:



Add that I'm wrong about a Chip on your Trigger Housing tooth.
Here's yours, compare it to the one I attached below it. Forget about the Peened punch marks on the 2nd picture